Absolute” Rated Pleated Filter Cartridges
This all polypropylene filter retains particles with absolute efficiency. Available in a broad range of pore sizes, it is suitable for a wide range of applications. The pleated construction provides a high surface area to offer outstanding overall filtration economy.
- Micron ratings from 0.2 to 25 μm– Broad application range
- Meets current USP Class VI biological test for plastics – Acceptable for food & beverage contact
- “Absolute” Efficiency– Rated at 99.98% (Beta 5000)
- Graded pore density– Multi-layer, graded density media – asymmetric pores for high dirt holding capacity
- Sufficient surface area– High flow rate, and long on-line service– Minimize maintenance cost
- Fixed matrix construction– Eliminates dirt unloading at maximum differential pressure
- Polypropylene Construction– Inert to many process fluids
- Various Gasket/O-Ring materials– Compatible with a variety of fluids
- Manufactured in continuous lengths up to 40 inches
|Gaskets/O-Rings options:||Buna-N, EPDM, Silicone, Viton, Teflon Encapsulated Viton (O-Rings only)|
|Micron ratings:||0.2, 0.45, 1.0, 2.5, 5.0, 10, 25 μm|
|*Other micron rated media available upon request|
|Dimensions and Operating Parameters|
|Nominal lengths:||24.7, 25.4, 50.8, 76.2, 101.6 cm|
|Inside diameter:||2.54 cm|
|Maximum operating temperature:||80°C|
|Differential pressure:||75 psid @ 70°F (5.2 bar @ 21°C)
40 psid @ 176°F (2.8 bar @ 80°C)
pressure for disposal: 35 psid (2.4 bar)
Filter Removal Efficiency
|Beta Ratio Efficiency||Beta 5000 99.98%||Beta 100 99%||Beta 50 98%|
|Beta Ratio =||
Upstream particle counts
Downstream particle counts
The micron ratings shown at various efficiency and beta ratio value levels were determined hrough laboratory testing, and can be used as a guide for selecting cartridges and estimating their performance.
Under actual field conditions, results may vary somewhat from the values shown due to the variability of filtration parameters. Testing was conducted using the single-pass test method, water at 3 gpm/10'' cartridge. Contaminants included latex beads, coarse and fine test dust. Removal efficiencies were determined using dual laser source particle counters.
All polypropylene material used in manufacturing complies with the regulations of the FDA title 21 of the Code of Federal Regulations Sections 174.5, 177.1520, and 177.1630, as applicable for food and beverage contact.