Titanium Porous Metal Technology TPM series filters are porous titanium filters designed for applications involving heat, gases, aggressive chemicals, cryogenics or polymers.
Made from titanium powder, that is sintered to form a rugged, fixed pore structure, TPM filtersare made to withstand temperature extremes, high pressuresand repeated cleaning/backwash cycles. T
here are no longitudinal seams, for improved mechanical strength and corrosion resistance. TOPM filters are produced in a range of configurations and micron ratings to perform in a variety of liquid and gas applications.
| Media: |
Titanium |
| End caps: |
Titanium |
| Gaskets/O-Rings options: | Buna-N, EPDM, Silicone, Viton, Teflon Encapsulated Viton (O-Rings only) |
| Micron ratings: |
0.2, 0.45, 1.0, 3.0, 10, 30 μm |
| *Other micron rated media available upon request | |
| Dimensions and Operating Parameters | |
|
P (DOE), P2 (226/flat), P3 (222/flat), M1 (3/4’’ male NPT), M2 (1’’ male NPT) |
|
| Nominal lengths: |
25.4, 50.8, 76.2cm |
| Outside diameter: | 70 mm or 60mm |
| Maximum operating temperature: | 371°C * |
| Differential pressure: |
250 psid (17.4 bar) forward 50 psid (3.5 bar) reverse |
|
* Max temperature applicable to NPT style filters only (No O-Rings or gaskets). Consult Graver Technologies for guidance on specific chemical/temperature compatibility. |
|
| Efficiency | |||
| Micron Rating | 99.5% | 95% | 90% |
| 0.5 micron | 0.5 | 0.3 | 0.1 |
| 2 micron | 2 | 0.8 | 0.4 |
| 5 micron | 5 | 3 | 1 |
| 10 microns | 10 | 8 | 5 |
| 15 microns | 15 | 12 | 10 |
| 35 microns | 35 | 32 | 28 |
• Corrosive liquids and gases • Cryogenic fluids • High viscosity solutions • Process steam • High temperature liquids and gases • Catalyst recovery
This website uses cookies.