FILTER ELEMENT TURBOGUARD

AEGIS® TurboGuard® Pre-Filters

AEGIS® TurboGuard® Pre-Filters

  • Flow is from the inside core to the outer pleats
  • TurboGuard Filters are wrapped in a one-piece extruded outer cage preventing media migration during inside out flow
  • TurboGuard’s one-piece extruded outer cage allows for easier maintenance and removal after use
  • One-piece molded end caps, including molded-in bail for secure handling during installation and removal
  • Quad Seal gasket system to provide maximum sealing surfaces
  • Highest dirt holding capacity – approximately 25 lbs (11.5 Kg) before removal is required
  • Low pressure drop – less than 0.2 bar in service at specified flow rate
  • Optimized media surface area allows full use of installed media area – not blocked off by media “squeezing

Typical Applications

  • Pre-filter for protection of Deep Bed demineralizers
  • Pre-filter for protection of RO membranes
  • Retrofit OEM high flow large geometry filter housings